Perkins — Perkins 402F-05, 403F-07, 403F-11, 403F-15 Industrial Engines Operation and Maintenance Manual

70 SEBU9064 Maintenance Recommendations Engine Oil and Filter - Change Replace the Oil Filter NOTICE Perkins oil filters are built to Perkins specifications. Use of an oil filter not recommended by Perkins could result in severe engine damage to the engine bearings, crankshaft, etc., as a result of the larger waste particles from unfiltered oil entering the engine lubricating system. Only use oil filters recommended by Perkins . 1. Remove the oil filter with a suitable tool. Note: The following actions can be carried out as part of the preventive maintenance program. 2. Cut the oil filter open with a suitable tool. Break apart the pleats and inspect the oil filter for metal debris.

An excessive amount of metal debris in the oil filter may indicate early wear or a pending failure. Use a magnet to differentiate between the ferrous metals and the nonferrous metals that are found in the oil filter element. Ferrous metals may indicate wear on the steel and cast iron parts of the engine. Illustration 41 g03380736 Typical example 3. Clean the sealing surface of the cylinder block. Nonferrous metals may indicate wear on the aluminum parts, brass parts, or bronze parts of the engine. Parts that may be affected include the following items: main bearings, rod bearings, turbocharger bearings and cylinder heads. 4. Apply clean engine oil to the new O ring seal (2).

NOTICE Do not fill the oil filters with oil before installing them. This oil would not be filtered and could be contami- nated. Contaminated oil can cause accelerated wear to engine components. Due to normal wear and friction, it is not uncommon to find small amounts of debris in the oil filter. Consult your Perkins dealer or your Perkins distributor in order to arrange for a further analysis if an excessive amount of debris is found in the oil filter. 5. Install the new oil filter (1) Spin on the oil filter until the O ring seal contacts the oil filter base. Rotate the oil filter ѕ of a full turn. Fill the Engine Crankcase 1. Remove the oil filler cap.

Refer to the Operation and Maintenance Manual for more information on lubricant specifications. Fill the crankcase with the correct amount of oil. Refer to the Operation and Maintenance Manual for more information on refill capacities. NOTICE If equipped with an auxiliary oil filter system or a re- mote oil filter system, follow the OEM or filter manu- facturer's recommendations. Under filling or overfilling the crankcase with oil can cause engine damage.