SEBU9064 71 Maintenance Recommendations Engine Valve Lash - Check NOTICE To prevent crankshaft bearing damage, crank the en- gine with the fuel OFF. This will fill the oil filters before starting the engine. Do not crank the engine for more than 30 seconds. NOTICE Only qualified service personnel should perform this maintenance. Refer to the Service Manual or your au- thorized Perkins dealer or your Perkins distributor for the complete valve lash adjustment procedure. Operation of Perkins engines with incorrect valve lash can reduce engine efficiency, and also reduce engine component life. 2. Start the engine and run the engine at LOW IDLE for 2 minutes.
Perform this procedure in order to ensure that the lubrication system has oil and that the oil filters are filled. Inspect the oil filter for oil leaks. 3. Stop the engine and allow the oil to drain back to the sump for a minimum of 10 minutes. Ensure that the engine can not be started while this maintenance is being performed. To help pre- vent possible injury, do not use the starting motor to turn the flywheel. Hot engine components can cause burns. Allow additional time for the engine to cool before meas- uring/adjusting valve lash clearance. Ensure that the engine is stopped before measuring the valve lash.
The engine valve lash can be inspected and adjusted when the temperature of the engine is hot or cold. Refer to Systems Operation, Testing and Adjusting, “Engine Valve Lash - Inspect/Adjust” for more information. Illustration 42 g03306420 (Y) ADD mark. (X) FULL mark. (A) Original oil level gauge (B) Alternative oil level gauge 4. Remove the oil level gauge in order to check the oil level. Maintain the oil level between the ADD and FULL marks on the oil level gauge. i05153520 Engine Valve Lash - Check This maintenance is recommended by Perkins as part of a lubrication and preventive maintenance schedule in order to help provide maximum engine life.
The maintenance for the valve lash is important in order to keep the engine compliant.