72 SEBU9064 Maintenance Recommendations Fan Clearance - Check i05153591 Fan Clearance - Check i05161054 Fuel Filter (In-Line) - Replace Fuel leaked or spilled onto hot surfaces or electri- cal components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. Note: Refer to Systems Operation, Testing, and Adjusting, “Cleanliness of Fuel System Components” for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. NOTICE Ensure that the engine is stopped before any servic- ing or repair is performed.
The location of the in-line fuel filter will depend on the application that the engine has been installed. Illustration 43 g03309719 Typical example Ensure that the engine is stopped. Ensure that the battery disconnect switch is in the OFF position. Ensure that the cooling system is full. The clearance between the cover (2) and the fan (1) will require checking. The gap between the edge of the cover and the tip of the fan blade (A) must be checked in four equally spaced positions. (A) equals 5 mm (0.19685 inch) for the three cylinder engine and the four cylinder naturally aspirated engine. (A) equals 10 mm (0.39370 inch) for the turbocharged engine.
Illustration 44 g03315616 Arrows show fuel flow Note: The cover is not adjustable. Note: The in-line fuel filter is an off engine part. 1. Turn the fuel supply valve (if equipped) to the OFF position. Remove clamp (3) and remove clamp (6). 2. Remove inlet hose (4) and remove outlet hose (5) from in-line filter (1).