Perkins — Perkins 402F-05, 403F-07, 403F-11, 403F-15 Industrial Engines Operation and Maintenance Manual

SEBU9064 73 Maintenance Recommendations Fuel Injector - Test/Change 3. If installed, remove clamp (2) and remove in-line filter (1) from application. The engine will not start or the engine is difficult to start. 4. Install new in-line filter (1) and install clamp (2). Not enough power 5. Install inlet hose (4) and install clamp (3). Install outlet hose (5) and install clamp (6). The engine misfires or the engine runs erratically. High fuel consumption 6. Turn the fuel supply valve (if equipped) to the ON position. Prime the system, refer to this Operation and Maintenance Manual, “Fuel System - Prime”. Black exhaust smoke The engine knocks or there is vibration in the engine.

i02154268 Fuel Injector - Test/Change Excessive engine temperature For further information on the removal and the installation of the fuel injectors, refer to the Disassembly and Assembly manual. For further information on the testing of fuel injectors, refer to the Testing and Adjusting manual. Identification of a suspect Fuel Injector Fuel leaked or spilled onto hot surfaces or electri- cal components can cause a fire. Make sure that you wear eye protection at all times during testing. When fuel injection nozzles are tested, test fluids travel through the orifices of the nozzle tip with high pressure.

Under this amount of pressure, the test fluid can pierce the skin and cause serious injury to the operator. Al- ways keep the tip of the fuel injection nozzle pointed away from the operator and into the fuel collector and extension. Work carefully around an engine that is running. Engine parts that are hot, or parts that are mov- ing, can cause personal injury. NOTICE If your skin comes into contact with high pressure fuel, obtain medical assistence immediately. NOTICE If a fuel injector is suspected of operating outside of normal parameters it should be removed by a quali- fied technician. The suspect fuel injector should be taken to an authorised agent for inspection.

NOTICE Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over discon- nected fuel system component. Operate the engine at a fast idle speed in order to identify the faulty fuel injector. Individually loosen and tighten the union nut for the high pressure pipe to each fuel injector. Do not loosen the union nut more than half a turn. There will be little effect on the engine speed when the union nut to the faulty fuel injector is loosened. Regular maintenance of the fuel injectors is recommended by Perkins . The fuel injectors must be removed and tested by an authorized agent.

The fuel injectors should not be cleaned as cleaning with incorrect tools can damage the nozzle. The fuel injectors should be renewed only if a fault with the fuel injectors occurs. Some of the problems that may indicate that new fuel injectors are needed are listed below: Consult your authorized Perkins dealer or your Perkins distributor for further assistance.