SEBU9064 79 Maintenance Recommendations Radiator - Clean A constant torque hose clamp can be used in place of any standard hose clamp. Ensure that the constant torque hose clamp is the same size as the standard clamp. Note: For the correct coolant, see this Operation and Maintenance Manual, “Fluid Recommendations”. 8. Refill the cooling system. Refer to the OEM information for further information on refilling the cooling system. Due to extreme temperature changes, the hose will harden. Hardening of the hoses will cause hose clamps to loosen. This can result in leaks. A constant torque hose clamp will help to prevent loose hose clamps. 9. Clean the cooling system filler cap.
Inspect the cooling system filler cap's seals. Replace the cooling system filler cap if the seals are damaged. Install the cooling system filler cap. Each installation application can be different. The differences depend on the following factors: 10. Start the engine. Inspect the cooling system for leaks. Type of hose Type of fitting material i02335774 Radiator - Clean Anticipated expansion and contraction of the hose Anticipated expansion and contraction of the fittings Replace the Hoses and the Clamps The radiator is not usually supplied by Perkins . The following text describes a typical cleaning procedure for the radiator.
Refer to the OEM information for further information on cleaning the radiator. Refer to the OEM information for further information on removing and replacing fuel hoses (if equipped). Note: Adjust the frequency of cleaning according to the effects of the operating environment. The coolant system and the hoses for the coolant system are not usually supplied by Perkins . The following text describes a typical method of replacing coolant hoses. Refer to the OEM information for further information on the coolant system and the hoses for the coolant system. Inspect the radiator for these items: Damaged fins, corrosion, dirt, grease, insects, leaves, oil and other debris.
Clean the radiator, if necessary. Personal injury can result from air pressure. Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pressure. Personal injury can result without following prop- er procedure. When using pressure air, wear a protective face shield and protective clothing. Maximum air pressure at the nozzle must be less than 205 kPa (30 psi) for cleaning purposes. 1. Stop the engine. Allow the engine to cool. Pressurized air is the preferred method for removing loose debris.
Direct the air in the opposite direction to the fan's air flow. Hold the nozzle approximately 6 mm (0.25 inch) away from the radiator fins. Slowly move the air nozzle in a direction that is parallel with the radiator tube assembly. This will remove debris that is between the tubes. 2. Loosen the cooling system filler cap slowly in order to relieve any pressure. Remove the cooling system filler cap. Note: Drain the coolant into a suitable, clean container. The coolant can be reused. 3. Drain the coolant from the cooling system to a level that is below the hose that is being replaced. Pressurized water may also be used for cleaning.
The maximum water pressure for cleaning purposes must be less than 275 kPa (40 psi). Use pressurized water in order to soften mud. Clean the core from both sides. 4. Remove the hose clamps. 5. Disconnect the old hose. Use a degreaser and steam for removal of oil and grease. Clean both sides of the core. Wash the core with detergent and hot water. Thoroughly rinse the core with clean water. 6. Replace the old hose with a new hose. 7. Install the hose clamps with a torque wrench.