Perkins — Perkins 402F-05, 403F-07, 403F-11, 403F-15 Industrial Engines Operation and Maintenance Manual

SEBU9064 81 Maintenance Recommendations Water Pump - Inspect Drain the water and the sediment from the fuel tank on a daily basis in order to ensure that only clean fuel enters the fuel system. Inspect the wiring and the wiring harnesses for loose connections and for worn wires or frayed wires. Inspect the ground strap for a good connection and for good condition. Disconnect any battery chargers that are not protected against the current drain of the starting motor. Check the condition and the electrolyte level of the batteries, unless the engine is equipped with a maintenance free battery. Check the condition of the gauges. Replace any gauges that are cracked.

Replace any gauge that can not be calibrated. i01907756 Water Pump - Inspect A failed water pump may cause severe engine overheating problems that could result in the following conditions: Cracks in the cylinder head A piston seizure Other potential damage to the engine Note: The water pump seal is lubricated by the coolant in the cooling system. It is normal for a small amount of leakage to occur as the engine cools down and parts contract. Visually inspect the water pump for leaks. Renew the water pump seal or the water pump if there is an excessive leakage of coolant.

Refer to the Disassembly and Assembly Manual, “Water Pump - Remove and Install” for the disassembly and assembly procedure.