Model 2120 Tractor Hydraulic System 70 TM-4252 (Dec-70) Selective Control Valve (Poppet Type) 30-9 7. Turn in two cam adjusting screws on lever side of housing evenly until they just touch the cam. Do not apply pressure. If screws appear uneven against cam, reposition cam plate and retighten set screws. 8. As soon as both set screws are contacting the cam plate evenly, back off return valve set screw 1/8 turn and secure with lock nut. Then back off set pressure valve screw 1/4 turn, securing also with lock nut. NOTE: The valve nearest to the "TOP" mark cast on the valve housing is a pressure valve, the other pressure valve being diagonally across from it (see fig. 10). 1503 9.
Tighten special screw securing cam plate to rocker (see 1, fig. 10) and press cam against both set screws. Fig. 9 Setting Neutral Position 1 Set screw 2 Dial indicator set at "0' 3 Special adjusting tool JDH-15C 4 Set screws NOTE: Each time the cam adjusting screws are backed off from the cams (creating a clearance between cam plates and adjusting screws), cams must be pried up against screws without loosening the cam-to-rocker attaching screws. 6. With the rocker held in neutral position, install a dial indicator with a minimum travel of 0.14 in. (= 3.6 mm). Seat dial indicator on control lever (see "a", fig. 11) at a distance of 2 in. (= approx.
50 mm) measured from the center of control lever shaft. Align dial indicator so that there is a sufficient distance to measure on both sides. Set dial indicator at zero. NOTE: It may be necessary to install control lever in reverse position (turned 180°) to mount dial indicator. Therefore, file a small groove in control lever where contacted by indicator feeler point. Fig. 11 Adjusting Valves a 2 in. (50 mm) 10. Loosen set screw of special adjusting tool for detent piston and rotate rocker in both directions. Fig. 10 Adjusting Cam Plate Set Screws 1 Special screw for securing cam 3 Set screws for return valves 4 Lock nut (4 used) plate 2 Set screws for pressure valves Printed in Germany