Model 2120 Tractor TM-4252 (Dec-70) Engine 20 Timing Gear Train 25-5 Install front thrust washer 5 over the spring pin 6, screwing the second cap screw 7 (see fig. 7) into the shaft. Secure gears against rotation and tighten screw to specified torque (see Torques for Hardware). y - \ SSs 0 X « W/////A// After final installation of all shafts and gears, check timing of the individual gears as explained above, using timing tool JD 254. Then withdraw timing pin from flywheel and flywheel housing and attach protective cover to flywheel housing. FINAL ASSEMBLY L 48440 Install oil slinger on crankshaft with flange facing away from engine.
Coat spring-loaded lip of timing cover oil seal with a film of high-temperature grease. Slide timing cover over crankshaft. However, be careful not to damage or turn over lip of oil seal. Install nuts and screws of timing cover and tighten to the specified torque. Fig. 7 Lower Idler Gear and Its Support Sectional View 1 Rear thrust washer 2 Cylinder block front plate 3 Idler gear 4 Idler gear bushing 5 Front thrust washer 6 Spring pin 7 Cap screws 8 Shaft 9 Special steel washer Cut off protruding edge of gasket between front plate and cylinder block or between front plate and timing cover so that it is flush with the oil pan sealing face.
If a new shaft is installed for the lower idler gear, drive spring pin 6 (fig. 7) in shaft so that it protrudes from front face of shaft by a specified value. Slide rear thrust washer 1 on shaft journal and spring pin. Drive in shaft until thrust washer is fully seated. Secure shaft with special steel washer 9 and cap screw 7. Tighten screw to specified torque (see Torques for Hardware). Install all parts of oil pressure regulating valve (see group 30). Install all engine or tractor parts removed to facilitate removal of parts dealt with in this group. upper idler gear and crankshaft gear ......... 0.0027 to 0.0116 in.
0.069 to 0.295 mm SPECIFICATIONS upper idler gear and camshaft gear .......... 0.0028 to 0.0135 in. 0.071 to 0.343 mm Dimensions of new parts Wear tolerance Timing gear backlash between upper idler gear and injection pump gear ....... 0.0028 to 0.0135 in. 0.071 to 0.343 mm 0.0166 in. 0.422 mm lower idler gear and crankshaft gear .......... 0.0027 to 0.0137 in. 0.069 to 0.348 mm 0.0185 in. 0.470 mm lower idler gear and balancer shaft gear ...... 0.0018 to 0.0156 in. 0.046 to 0.396 mm 0.0185 in. 0.470 mm 0.0187 in. 0.475 mm 0.0206 in. 0.523 mm Printed in Germany