John Deere 2120 Tractor — tm4252

20 Engine 25-4 Timing Gear Train Model 2120 Tractor TM-4252 (Dec-70) Make sure that the rear thrust washer 1 (fig. 5) is installed. If a new shaft is installed, first drive spring pin 6 (fig. 5) in shaft so that it protrudes from the front face of the shaft by a specified dimension (see Specifications). Install front thrust washer 5 and cap screw 7, secure gears against rotation and tighten screw to the specified torque (see Torques for Hardware). 8. While the crankshaft is set in its TDC position in accordance with paragraph 2, align both balancer shaft gears with the aid of timing tool No. JD 254. Rotating the balancer shafts, set the balancer gear markings (see "d" and "e", fig.

6) so that they are in alignment with the centre of the crankshaft and balancer shaft (see fig. 6). Fig. 4 - Timing Injection Pump Gear, Using Timing Tool No. JD 254 c Timing mark 7. After having timed the camshaft and injection pump gear, carefully slide upper idler gear on shaft, simultaneously engaging the gear in crankshaft, camshaft and injection pump gears with a rotating motion. Use special care not to rotate the pre¬ viously timed gears. Fig. 6 Timing Balancer Shaft Gear by means of Timing Tool No. JD 254 d Timing mark on right-hand balancer shaft gear e Timing mark on left-hand balancer shaft gear 9.

After having timed the balancer shaft gears, carefully slide the lower idler gear onto the shaft, simultaneously engaging the gear in the crankshaft, lubricating oil pump and right-hand balancer shaft gears with a rotating motion. Take extra care not to rotate the previously timed gears. Make sure that rear thrust washer 1 (fig. 7) has been installed. L 48439 \ Fig. 5 - Upper Idler Gear and Support - Sectional View 1 Rear thrust washer 5 Front thrust washer 2 Cylinder block front plate 6 Spring pin 3 Idler gear 7 Cap screw 4 Idler gear bushing 8 Shaft Printed in Germany