MAINTENANCE ASTM: American Society of Testing ans Material SAE: Society of Automotive Engineers API: American petroleum Institute 20.1 ENGINE OIL SPECIFICATIONS Normal operation Oil performance recommendations are as follows: The use of a quality engine lubricating oil combined with appropriate oil and filter change intervals are critical factors in maintaining engine performance and durability. SAE 15W-40 multi-viscosity oil meeting the American Petroleum Institute (API) performance classification of CE/SG is recommended. NOTE:
CC/CD or CD/SF oils may be used in areas where CE oil is not yet available but the oil change interval must be reduced to one half the interval given in the maintenance schedule A sulfated ash limit of 1.0 mass percent is suggested for optimum valve and piston deposit and oil consumption control. the sulfated ash must not exceed 1.85 mass percent. The sulfated ash limit of 1.85 mass percent has been placed on all engine lubricating oils recommended for use in the engine. Higher ash oils can cause valve and/or piston damage and lead to excessive oil consumption.
The API service symbol displays the appropriate oil categories; the lower half may contain words to describe oil energy conserving features. The center section identifies the SAE oil viscosity grade. Oil viscosity recommendations are as follows: The use of a multi-graded lubricating oil has been found to improve oil consumption control and improve engine cranking in cold temperatures while maintaining lubrication at high operating temperatures. While SAE 15W-40 multi-viscosity oil is recommended for most operating climates, refer to the previous chart for oil viscosity recommendations for extreme climates. NOTE:
limited use of low viscosity oils, such as 10W-30 may be used for easier starting and providing sufficient oil flow at ambient temperatures below -5 E C (23 E F). However, continuous use of low viscosity oil can decrease engine life due to wear. Single graded oils may be used if multi-graded oil is not available. But be sure to use oil that matches the temperature shown in the table. Special break-in lubricating oils are not recommended for a new or rebuilt engine. Use the same type of oil during the break-in as specified for normal operation. Additional information regarding lubricating oil availability throughout the world is available in the "E.M.A.
Lubricating Oils Data Book For Heavy Duty Automotive and Industrial Engines". The data book may be ordered from the Engine Manufacturers Association, 401 North Michigan Ave., Chicago, Il U.S.A. 60611. The telephone number is (312) 644- 6610. Arctic Operation If an engine is operated in ambient temperatures consistently below -23 E C (-10 E F) and there are no provisions to keep the engine warm when it is not in operation, use a synthetic API performance classification CE or CF-4 engine oil with adequate low temperature properties such as SAE 5W-20 or 5W-30. The oil supplier must be responsible for meeting the performance service specifications. IMPORTANT:
The use of a synthetic base oil does not justify extended oil change intervals. Extended oil change intervals can 3-10 О