Operation EMU27763 Forward (tiller handle and remote control models) Tiller control models 1. Place the throttle grip in the fully closed position. 2. Move the gear shift lever quickly and firmly from neutral to forward. Remote control models 1. Pull up the neutral interlock trigger (if equipped) and move the remote control lever quickly and firmly from neutral to forward. lever quickly and firmly from neutral to reverse. EMU27820 Stopping engine Before stopping the engine, first let it cool off for a few minutes at idle or low speed. Stop- ping the engine immediately after operating at high speed is not recommended. EMU27851 Procedure 1. Turn the main switch to “ ” (off).
EMU27784 Reverse (automatic reverse lock and power trim and tilt models) EWM00190 When operating in reverse, go slowly. Do not open the throttle more than half. Oth- erwise the boat could become unstable, which could result in loss of control and an accident. WARNING 2. After stopping the engine, disconnect the fuel line or close the fuel cock if there is a fuel joint or a fuel cock on the boat. 3. Tighten the air vent screw on the fuel tank cap (if equipped). 4. Remove the key if the boat will be left unattended. NOTE: The engine can also be stopped by pulling the lanyard and removing the clip from the Tiller control models 1. Place the throttle grip in the fully closed position. 2.
Move the gear shift lever quickly and firmly from neutral to reverse. Remote control models 1. Pull up the neutral interlock trigger (if equipped) and move the remote control 33