Operation Adjust the outboard motor trim angle using the power trim and tilt switch. results in less drag, greater stability and effi- ciency. This is generally when the keel line of the boat is up about 3 to 5 degrees. With the bow up, the boat may have a greater tenden- cy to steer to one side or the other. Compen- sate for this as you steer. The trim tab can also be adjusted to help offset this effect. When the bow of the boat is down, it is easier to accelerate from a standing start onto plane. 1. Power trim and tilt switch 1 UP Bow Up Too much trim-out puts the bow of the boat too high in the water.
Performance and econ- omy are decreased because the hull of the boat is pushing the water and there is more air drag. Excessive trim-out can also cause the propeller to ventilate, which reduces per- formance further, and the boat may “por- poise” (hop in the water), which could throw the operator and passengers overboard. DN ZMU03522 1. Power trim and tilt switch To raise the bow (trim-out), press the switch ” (up). To lower the bow (trim-in), press the switch ” (down). Make test runs with the trim set to different angles to find the position that works best for your boat and operating conditions. NOTE:
To adjust the trim angle while the boat is moving, use the power trim and tilt switch lo- cated on the remote control device or tiller handle, if equipped. EMU27911 Adjusting boat trim When the boat is on plane, a bow-up attitude 35