3. FUNCTION OF HYDRAULIC MOTOR 3. FUNCTION OF HYDRAULIC MOTOR 1) 1) TURNING FORCE GENERATION TURNING FORCE GENERATION The pressure oil delivered from the hydraulic pump flows to rear flange of the motor, passes through the brake valve mechanism, and is introduced into cylinder block (204) via timing plate (209). This oil constructively introduced only to one side of Y1-Y2 connecting the upper and lower dead points of stroke of piston (205). The pressurized oil fed to one side in cylinder block (204) pushes each piston (205) (four or five) and generates a force F(kgf) = P(kgf/cm 2 ) Ч A (cm 2 ).
This force acts on swash plate (203), and is resolves into components (F2 and F3) because swash plate (203) is fixed at an angle ( α° α° ) with the axis of drive shaft (202). Radial component (F3) generates respective torques (T=F3 Ч RI) for (Y1)-(Y2). This residual of torque (T = S (F3 Ч RI)) rotates cylinder block (204) via piston (205). Cylinder block (204) is spline coupled with drive shaft (202). So the drive shaft (202) rotates and the torque is transmitted. Y1 Y2 4809S2TM03 2-73 F3 R1 Swash plate(203) Piston(206) Cylinder block(204) F2 O α° F1 A P F3 High pressure Cylinder block(204) F2 α° A F1 P Low pressure