hyundai R510LC-7 — 4. TRAVEL DEVICE

7) 7) WORKING PRINCIPLE OF REDUCTION GEAR WORKING PRINCIPLE OF REDUCTION GEAR R R C C3 C2 C1 P3 P2 P1 S3 S2 S1 4809S2TM09 The reduction gear is composed of a three-stage planetary gear mechanism shown in the following figure. Since the sun gear is designed to have a floating mechanism, errors of the gears and carrier pin hole pitches will not affect the gear's lives heavily. The input rotation of the hydraulic motor is transmitted to the drive gear (D) and this drives the No. 1 planetary gears (P1).

This No.1 planetary gears (P1) drives the cover gear (C) with the same force as the meshing tangential force with the drive gear (D), and also the No.1 carrier (C1) with the same force as the meshing reaction force. In other words, the No.1 planetary gears (P1) revole rotating. This rotation of the No.1 carrier (C1) becomes the output of the 1st stage, and is transmitted directly to No.2 sun gear (S2). (No.1 carrier is spline-coupled with No.2 sun gear.) Similarly the revolution of the No.2 planetary gears (P2) are transmitted via No.2 carrier (C2) to the No.3 sun gear (S3).

Since the No.3 carrier (C3) supporting the No.3 planetary gears (P3) are fixed, the No.3 planetary gears (P3) do not revolve, but rotates to drive ring gear (R). Therefore, the rotating case is driven by the overall driving torque of the cover and ring gear. This reduction ratio is expressed as shown below : I = -1 (Z D + Z C )(Z S2 + Z R )(Z S3 + Z R ) Z D Ч Z S2 Ч Z S3 Z D : Teeth of the drive gear Z C : Teeth of the cover gear Z S2 : Teeth of the No.2 sun gear Z S3 : Teeth of the No.3 sun gear Z R : Teeth of the ring gear The direction of rotation is reverse to that of the input shaft. 2-79