hyundai R510LC-7 — 2. MODE SELECTION SYSTEM

2. WORK MODE SELECTION SYSTEM 3 work modes can be selected for the optional work speed of the machine operation. Main control valve Boom priority solenoid valve Power boost solenoid valve Max flow CO solenoid valve Engine Main pump Pilot pump Max flow CO valve Hyd temp sensor CAN + EPPR valve Emergency Normal Emergency (optional) Accel dial Serial Communication(-) Serial Communication(+) Drive signal Prolix Resistor 51075MS03 1) HEAVY DUTY WORK MODE The boom priority solenoid is activated to make the boom operation speed faster. 2) GENERAL WORK MODE When key switch is turned ON, this mode is selected and swing operation speed is faster than heavy duty work mode.

3) BREAKER OPERATION MODE It sets the pump flow to the optimal operation of breaker by activating the max flow cut-off solenoid. 5-4 Arm1 Option Arm2 Boom 2 Bucket Swing Boom 1 Travel(RH) Travel(LH) Boom priority valve Main relief valve Arm1 Option Boom 2 Swing Travel(RH) ECM CAN- GND MCU Hyd temperature signal Drive signal Drive signal Drive signal Accel dial signal Work mode Boom priority solenoid Max flow cut-off solenoid Heavy duty ON OFF General OFF OFF Breaker OFF ON