GROUP 7 ENGINE OVERHEAT PREVENTION FUNCTION Engine ECM Main pump Pilot pump Max flow CO valve CAN + GND - CAN Drive signal Overheat warming signal MCU Cluster 51075MS08 1. MCU receives engine coolant temperature from the ECM and when the engine coolant boils up to 110 C , it sends overheat warning signal to the cluster and decrease the engine speed same as accel dial 7 position. 2. If the coolant temperature drops less than 100 C, the MCU returns the mode to the mode set before. And if mode set is changed during the function, the MCU cancels the function.
Even if the overheat prevention function is canceled by mode change, the overheat warning lamp turns OFF only when the coolant temperature is less than 100 C. 3. LOGIC TABLE 5-10 EPPR valve Description Condition Function Actuated - Coolant temperature : Above 110 C - Accel dial set : Above 8 - Engine rpm drop to accel dial 7 position - Overheat warning lamp & buzzer : ON Canceled - Coolant temperature : Less than 100 C - Changed mode set by operator If any of the above conditions is applicable, engine overheat prevention function is canceled - Return to the mode and accel dial set before - Hold on the changed set Overheat warning lamp - Coolant temperature :
Less than 100 C - Overheat warning lamp : OFF