4. ENGINE FAULT CODE INFORMATION (For QSM11) 5-15 Fault code No. Reason Effect(only when fault code is active) 111 Error internal to the ECM related to memory hardware failures or internal ECM voltage supply circuits. Engine will not start. 115 No engine speed signal detected at both engine position sensor circuits. Engine will die and will not start. 121 No engine speed signal detected from one of the engine position sensor circuits. None on performance. 122 High voltage detected on the intake manifold pressure circuit. Derate in power output of the engine. 123 Low voltage detected on the intake manifold pressure circuit. Derate in power output of the engine.
131 High voltage detected at the throttle position signal circuit. Severe derate(power and speed). Limp home power only. 132 Low voltage detected at the throttle position signal circuit. Severe derate(power and speed). Limp home power only. 133 High voltage detected at the remote throttle position signal circuit. None on performance if remote throttle is not used. 134 Low voltage detected at the remote throttle position signal circuit. None on performance if remote throttle is not used. 135 High voltage detected at the oil pressure circuit. No engine protection for oil pressure. 141 Low voltage detected at the oil pressure circuit. No engine protection for oil pressure.
143 Oil pressure signal indicates oil pressure below the low oil pressure engine protection limit. Progressive power and speed derate with increasing time after alert. If engine protection shutdown feature is enable, engine will shut down 30 seconds after red lamp starts flashing. 144 High voltage detected at the coolant temperature circuit. Possible white smoke. Fan will stay on if controlled by the electronic control module (ECM). No engine protection for coolant temperature. 145 Low voltage detected at the coolant temperature circuit. Possible white smoke. Fan will stay on if controlled by electronic control module (ECM). No engine protection for coolant temperature.
147 A frequency of less then 100Hz was detected at the frequency throttle signal pin of the actuator harness connector at the ECM. Calibration dependent power and speed derate. 148 A frequency of more than 100Hz was detected at the frequency throttle signal pin of the actuator harness connector at the ECM. Calibration dependent power and speed derate. 151 Coolant temperature signal indicates coolant temperature above 104 C(220 F). Progressive power derate with increasing time after alert. If engine protection shutdown feature is enabled, engine will shut down 30 seconds after red lamp starts flashing. 153 High voltage detected at the intake manifold temperature circuit. Possible white smoke.
Fan will stay on if controlled by electronic control module (ECM). No engine protection for coolant temperature. 154 Low voltage detected at the intake manifold temperature circuit. Possible white smoke. Fan will stay on if controlled by electronic control module (ECM). No engine protection for coolant temperature. 155 Intake manifold temperature signal indicates temperature above 87.8 C(190 F). Progressive power derate with increasing time after alert. If engine protection shutdown feature is enabled, engine will shut down 30 seconds after red lamp starts flashing. 187 Low voltage detected on the ECM voltage supply line to some sensors(VSEN2 supply). Engine will run derated.
No engine protection for oil pressure and coolant level.