5-16 Fault code No. Reason Effect(only when fault code is active) 211 Additional machine diagnostic codes have been logged. Check other ECM’s for diagnostic codes. None on engine performance. 212 High voltage detected at the oil temperature circuit. No engine protection for oil temperature. 213 Low voltage detected at the oil temperature circuit. No engine protection for oil temperature. 214 Oil temperature signal indicates oil temperate above 123.9 C(225 F). Progressive power derate with increasing time after alert. If engine protection shutdown feature is enabled, engine will shut down 30sec after the red lamp starts flashing.
219 Low oil level was detected in the CentinelTM makeup oil tank. None on performance. CentinelTMdeactivated. 221 High voltage detected at the ambient air pressure circuit. Derate in power output of the engine. 222 Low voltage detected at the ambient air pressure circuit. Derate in power output of the engine. 223 Incorrect voltage detected at the CentinalTM actuator circuit by the ECM. None on performance. CentinelTMdeactivated. 227 High voltage detected on the ECM voltage supply line to some sensors(VSEN2 supply). Engine will run derated. No engine protection for oil pressure and coolant level. 234 Engine speed signal indicates engine speed is greater than 2730 rpm.
Fuel shutoff valve closes until engine speed falls to 2184 rpm. 235 Coolant level signal indicates coolant level is below the normal range. Progressive power derate with increasing time after alert. If engine protection shutdown feature is enabled, engine will shut down 30 seconds after red lamp starts flashing. 237 Duty cycle of the throttle input signal to the primary or secondary engine for multiple unit synchronization is less than 3 percent or more than 97 percent. All engines(primary and secondary) are shut down with increasing time after alert if hard- coupled. Only secondary engines are shut down with increasing time after alert if soft- coupled.
241 The ECM lost the vehicle speed signal. Engine speed limited to maximum engine speed without vehicle speed sensor parameter value Cruise Control. Gear-Down Protection and Road Speed Governor will not work (automotive only). 242 Invalid or inappropriate vehicle speed signal detected. Signal indicates an intermittent connection or VSS tampering. Engine speed limited to maximum engine speed without vehicle speed sensor parameter value Cruise Control. Gear-Down Protection and Road Speed Governor will not work (automotive only). 245 Less than 6 VDC detected at fan clutch circuit when on. Indicates an excessive current draw from the ECM or faulty ECM output circuit.
The fan may stay on at all times. 254 Less than 6 VDC detected at FSO circuit when on. Indicates an excessive current draw from the ECM or a faulty ECM output circuit. The ECM turns off the FSO supply voltage. The engine will shut down. 255 Externally supplied voltage detected going to the fuel shutoff solenoid supply circuit. None on performance. Fuel shutoff valve stays open. 285 The ECM expected information from a multiplexed device but did not receive it soon enough or did not receive it at all. At least one multiplexed device will not operate properly. 286 The ECM expected info from a multiplexed device but only received a portion of the necessary information.
At least on multiplexed device will not operate properly. 287 The machine vehicle electronic control unit (VECU) detected a fault with its throttle pedal. The engine will only idle.