5-17 Fault code No. Reason Effect(only when fault code is active) 288 The machine vehicle electronic control unit (VECU) detected a fault with its remote throttle. The engine will not respond to the remote throttle. 293 High voltage detected at the machine temperature sensor signal pin of the 31-pin machine connector. No engine protection for machine temperature. 294 Low voltage detected at the machine temperature sensor signal pin of the 31-pin machine connector. No engine protection for machine temperature. 295 An error in the ambient air pressure sensor signal was detected by the ECM. Engine is derated to no air setting.
297 High voltage detected at the machine pressure sensor signal pin of the 31-pin machine connector. No engine protection for machine pressure. 298 Low voltage detected at the machine pressure sensor signal pin of the 31-pin machine connector. No engine protection for machine pressure. 299 Engine shutdown by device other than key switch before proper engine cool down resulting in filtered load factor above maximum shutdown threshold. No action taken by the ECM. 311 Current detected at No.1 injector when voltage is turned off. Current to injector is shut off. 312 Current detected at No.5 injector when voltage is turned off. Current to injector is shut off.
313 Current detected at No.3 injector when the voltage is turned off Current to injector is shut off. 314 Current detected at No 6 injector when the voltage is turned off. Current to injector is shut off. 315 Current detected at No.2 injector when the voltage is turned off. Current to injector is shut off. 319 Real time clock lost power. None on performance. Data in the ECM will not have accurate time and date information. 321 Current detected at No.4 injector when the voltage is turned on. Current to injector is shut off. 322 No current detected at No.1 injector when the voltage is turned on. Current to injector is shut off.
323 No current detected at No.5 injector when the voltage is turned on. Current to injector is shut off. 324 No current detected at No.3 injector when the voltage is turned on. Current to injector is shut off. 325 No current detected at No.6 injector when the voltage is turned on. Current to injector is shut off. 331 No current detected at No.2 injector when the voltage is turned on. Current to injector is shut off. 332 No current detected at No.4 injector when the voltage is turned on. Current to injector is shut off. 341 Severe loss of data from the ECM. Possible no noticeable performance effects OR engine dying OR hard starting.
Fault information, trip information and maintenance monitor data may be inaccurate. 343 Internal ECM error. Possible none on performance or severe derate. 349 A frequency greater than calibrated threshold was detected at the tail shaft governor signal pin of the 31-pin machine connector. Calibration dependent power and speed derate. 352 Low voltage detected on the ECM voltage supply line to some sensors (VSEN 1 supply). Engine is derated to no air setting.