hyundai R510LC-7 — 10. ENGINE CONTROL SYSTEM

GROUP 10 ENGINE CONTROL SYSTEM 1. MCU (Machine control unit) AND ECM (Electronic control module) 1 MCU 2 Electric box 3 Bolt(M8) 45075MS06 G : green, R : red, Y : yellow 5-20 2. MCU ASSEMBLY 1) To match the pump absorption torque with the engine torque, MCU varies EPPR valve output pressure, which control pump discharge amount whenever feedbacked engine speed drops under the reference rpm of each mode set. 2) Three LED lamps on the MCU display as below.

LED lam G is turned ON G and R are tur G and Y are tur Three LED are OFF p Trouble Service Normal - ned ON Trouble on MCU Change the MCU ned ON Trouble on serial communication line Check if serial communication lines between controller and cluster are disconnected turned Trouble on MCU power Check if the input power wire (24 V, GND) of controller is disconnected Check the fuse