hyundai R510LC-7 — 3. ELECTRICAL SYSTEM

GROUP 3 ELECTRICAL SYSTEM 1. WHEN STARTING SWITCH IS TURNED ON, MONITOR PANEL DISPLAY DOES NOT APPEAR Before disconnecting the connector, always turn the starting switch OFF. Before carrying out below procedure, check all the related connectors are properly inserted and short of fuse No.9. After checking, insert the disconnected connectors again immediately unless otherwise specified. 6-24 Cause Remedy YES Check voltage Defective clucter Replace YES between CN-56 (1) and chassis Disconnection in Repair or NO wiring harness or replace Check voltage poor contact (After clean) between CN-5(3) and chassis between CN-5(3)- CN-56(1) Starting switch : ON Voltage :

20~32V Disconnection in Repair or NO wiring harness or replace poor contact (After clean) between CN-5(3)- and fuse No.9 Cause Remedy Defective clucter Disconnection in wiring harness or poor contact between CN-5(3)- CN-56(1) Disconnection in wiring harness or poor contact between CN-5(3)- and fuse No.9 Replace Repair or replace (After clean) Repair or replace (After clean) CLUSTER FUSE POWER IG(24V) 1 3 NO.9 GND 2 9 RX TX CN-56 CN-5 Check voltage YES 20 ~ 32V NO 0V 51076ES01 YES 20 ~ 32V NO 0V