hyundai R510LC-7 — 3. ELECTRICAL SYSTEM

2. COMMUNICATION ERROR "Co : Er" FLASHES ON THE CLUSTER Before disconnecting the connector, always turn the starting switch OFF. Before carrying out below procedure, check all the related connectors are properly inserted. After checking, insert the disconnected connectors again immediately unless otherwise specified.

Check voltage between CN-5 (10,11)and chassis KEY ON Check voltage CONTROLLER 29 CN-50 30 CLUSTER POWER IG(24V) GND RX *12V 2 3 10 9 TX *4V 4 CN-56 11 CN-5 29076ES02 6-25 YES Check voltage S between CN-56 (3,4) and chassis NO Cause Remedy Defective controller Disconnection in wiring harness or poor contact between CN-56 (3,4) CN-5(10,11) Disconnection in wiring harness or poor contact between CN-5 (10,11)-CN-50 (29,30) Replace Repair or replace (After clean) Repair or replace (After clean) NO YES * 4V *12V NO 0V 0V