Starting switch : ON Work lamp switch : ON-OFF Voltage : 20~30V Check voltage between CN-116 (10,11) and chassis 16. WHEN STARTING SWITCH IS TURNED ON, WORK LAMP DOES NOT LIGHTS UP After checking, insert the disconnected connectors again immediately unless otherwise specified. Before carrying out below procedure, check all the related connectors are properly inserted and short of fuse No.17. Before disconnecting the connector, always turn the starting switch OFF.
YES NO Check voltage between CN-116 (2, 3) and chassis NO YES Defective bulb Defective lamp switch Cause Remedy Replace Replace switch 6-39 10 8 2 CN-7 1 2 CN-12 NO.17 FUSE SWITCH PANEL 4 5 6 7 8 9 10 11 12 13 14 15 16 17 3 2 1 CN-116 CL-6 2 1 WORK LAMP CL-5 2 1 WORK LAMP WIPER MOTOR DRIVE CABIN LIGHT 24V CABIN LIGHT 24V TRAVEL ALARM WASHER SIG WORK LIGHT 24V WORK LIGHT 24V HEAD LIHGT 24V CABIN LIGHT OUT CABIN LIGHT OUT POWER 24V WORK LIGHT OUT WORK LIGHT OUT HEAD LIGHT OUT INT. SIG GND PRE-HEAT 36076ES09 NO Check voltage YES between CN-116 YES (2, 3) and chassis Check voltage YES between CL-5(2) Starting switch : ON Work lamp switch : ON and chassis Voltage : 20~30V NO Starting switch :
ON Work lamp switch : ON Check voltage Voltage : 20~30V between CN-7(2) YES and chassis Starting switch : ON Work lamp switch : ON Check voltage Voltage : 20~30V between CN-116 (10,11) and NO chassis Starting switch : ON Work lamp switch : ON-OFF Voltage : 20~30V YES Check voltage between CN-7(8) NO and chassis Head lamp switch : ON Voltage : 20~30V NO Cause Remedy Defective lamp switch Defective bulb Disconnection in wiring harness or poor contact between CN-7(1) -CL-5(2) and CL-6(2) Disconnection in wiring harness or poor contact between CN-116 (2,3)-CN-7(2) Disconnection in wiring harness or poor contact between CN-116 (10,11)-CN-7(8) Recheck fuse No.
17 Replace switch Replace Repair or replace (After clean) Repair or replace (After clean) Repair or replace (After clean) Replace 1 2 1 2