Starting switch : ON Head lamp switch : ON-OFF Check voltage between CN-116 (9) and chassis 15. WHEN STARTING SWITCH IS TURNED ON, HEAD LAMP DOES NOT LIGHTS UP After checking, insert the disconnected connectors again immediately unless otherwise specified. Before carrying out below procedure, check all the related connectors are properly inserted and short of fuse No.16. Before disconnecting the connector, always turn the starting switch OFF.
NO YES Check voltage between CN-116 (1) and (9) NO YES Defective bulb Defective lamp switch Cause Remedy Replace Replace switch 6-38 10 7 1 CN-7 NO.16 FUSE 4 5 6 7 8 9 10 11 12 13 14 15 16 17 SWITCH PANEL 3 2 1 CN-116 CR-13 CL-4 1 2 HEAD LAMP CL-3 1 2 HEAD LAMP WIPER MOTOR DRIVE HEAD LAMP 87a 86 85 87 86 87a 30 CABIN LIGHT 24V CABIN LIGHT 24V TRAVEL ALARM WORK LIGHT 24V WORK LIGHT 24V HEAD LIHGT 24V CABIN LIGHT OUT CABIN LIGHT OUT WORK LIGHT OUT WORK LIGHT OUT HEAD LIGHT OUT 30 85 87 INT. SIG WASHER SIG POWER 24V PRE-HEAT GND 51076ES06 2 1 NO Check voltage YES between CN-116 YES (1) and (9) Check voltage YES between CL-4(1) Starting switch : ON Head lamp switch : ON and chassis Voltage :
20~30V NO Starting switch : ON Check voltage Head lamp switch : ON Voltage : 20~30V between CN-7(1) YES and chassis Starting switch : ON Head lamp switch : ON Check voltage Voltage : 20~30V NO between CN-116 (9) and chassis Starting switch : ON Head lamp switch : ON-OFF YES Check voltage between CN-7 NO (7) and chassis Head lamp switch : ON NO Cause Remedy Defective lamp switch Defective bulb Disconnection in wiring harness or poor contact between CN-7(1)- CL-4(1) Disconnection in wiring harness or poor contact between CN-116(1)-CN- 7(1) Disconnection in wiring harness or poor contact between CN-116 (9)-CN-7(7) Recheck fuse No.
16 Replace switch Replace Repair or replace (After clean) Repair or replace (After clean) Repair or replace (After clean) Replace 2 1