hyundai R510LC-7 — 3. ELECTRICAL SYSTEM

Front sliding door open-close Check operation wiper cut switch between Voltage :

0~1V Washing Intermittent YES Check voltage between CN-141 YES YES Disconnection in wiring harness or poor contact between CN-141 (11)- CS-53 Defective wiper cut switch Cause Remedy Repair or replace (After clean) Replace 6-37 MOTOR DRIVE- MOTOR DRIVE SIG FEED BACK WIPER MOTOR 2 6 M CN-141 4 5 3 CN-21 3 2 1 6 5 4 3 2 1 CN-17 8 7 6 5 4 3 2 1 CN-9 CN-7 CN-6 CN-5 4 10 9 5 3 11 10 9 6 5 4 1 WASHER TANK M CN-22 NO.13 FUSE 1 2 NO.15 FUSE NO.5 FUSE 36076ES07 3 5 4 6 M 2 1 2 3 4 5 6 NO YES Check operation wiper cut switch Front sliding door Check voltage open-close between CN-141 YES YES (11) and chassis Check voltage NO Front sliding door-close between CN-116 Voltage :

4~5V (6) and chassis Check operation NO of switch panel Starting switch : ON NO LED ON. Voltage : 20~30V Starting switch : ON YES Push wiper switch button Check voltage between NO CN-116(4) and chassis Intermittent NO Check voltage CN-116 (12) and chassis Check operation Washing of wiper motor Check voltage CN-116 and controller (15) and chassis check voltage YES CN-141(7) and Starting switch : ON chassis, CN-21(4) Voltage : 0~1V and chassis NO Starting switch : OFF Check voltage Voltage : 20~30V CN-141(6)-and YES chassis Check continuity Starting switch :

ON YES NO between CN-141(2)-CN-116(4), CN-141(9)-CN-116(12), CN-141(10)-CN-116(15), NO CN-141(5)-Chassis , Check wiper CN-141(1)-CN-21(5), motor resistance CN-141(3)-CN-21(6), between CN-21 YES CN-141(4)-CN-21(2), (2)-CN-21(6) CN-141(13)-CN-21(3) YES Resistance :

3~4 Cause Remedy Defective wiper cut switch Disconnection in wiring harness or poor contact between CN-141 (11)- CS-53 Defective switch panel 1)Recheck fuse NO.13 2)Disconnection in wiring harness or poor contact between CN- 116(6)-Fuse between CN- 116(13)-Chassis Defective switch panel 1) Recheck fuse NO.5 2) Disconnection in wiring harness or poor contact between CN- 141(7)-Fuse, CN-21(4)-Fuse 1) Recheck fuse NO.15 2) Disconnection CN-141(6)-Fuse Disconnection in wiring harness or poor contact Defective wiper motor Defective wiper motor controller Replace Repair or replace (After clean) Replace Replace Repair or replace (After clean) Replace Replace Repair or replace (After clean) Replace Repair or replace (After clean) Repair or replace (After clean) Replace Replace 5 6 9 10 11 2 1 M Check voltage between CN-116(4) an Intermittent Check voltag CN-116(4) an d chassis Check voltag e CN-116 (12) and chas Washing Check voltag (12) and chas sis Check voltag e CN-116 (15) and chas sis