hyundai R510LC-7 — 3. PUMP DEVICE

(14) Remove valve plates(313, 314) from valve cover(311, 312). These may be removed in work 7, 9. 36078MP09 (15) If necessary, remove stopper (L, 534), stopper(S, 535), servo piston(532) and tilting pin(531) from pump casing(271), and needle bearing(124) from valve cover(311, 312). In removing tilting pin, use a protector to prevent pin head from being damaged. Since loctite is applied to fitting areas of tilting pin and servo piston, take care not to damage servo piston. Do not remove needle bearing as far as possible, except when it is considered to be out of its life span. Do not loosen hexagon nuts of valve cover and swash plate support. If loosened, flow setting will be changed.

(16) This is the end of disassembling procedures. 8-15