hyundai R510LC-7 — 3. PUMP DEVICE

4) ASSEMBLY (1) For reassembling reverse the disassem- bling procedures, paying attention to the following items. Do not fail to repair the parts damaged during disassembling, and prepare replacement parts in advance. Clean each part fully with cleaning oil and dry it with compressed air. Do not fail to apply clean working oil to sliding sections, bearings, etc. before assembling them. In principle, replace seal parts, such as O-rings, oil seals, etc. For fitting bolts, plug, etc., prepare a torque wrench or so on, and tighten them with torques shown in page 8-11, 12. For the double-pump, take care not to mix up parts of the front pump with those of the rear pump.

(2) Fit swash plate support(251) to pump casing(271), tapping the former lightly with a hammer. After servo piston, tilting pin, stopper(L) and stopper(S) are removed, fit them soon to pump casing in advance for reassembling. In tightening servo piston and tilting pin, use a protector to prevent tilting pin head and feedback pin from being damaged. In addition, apply loctite(Medium strength) to their threaded sections. 36078MP10 8-16