(3) Place pump casing with its regulator fitting surface down, fit tilting bush of swash plate to tilting pin(531) and fit swash plate (212) to swash plate support(251) correctly. Confirm with fingers of both hands that swash plate can be removed smoothly. Apply grease to sliding sections of swash plate and swash plate support, and drive shaft can be fitted easily. 36078MP11 (4) To swash plate support(251), fit drive shaft(111) set with bearing(123), bearing spacer(127) and snap ring(824). Do not tap drive shaft with hammer or so on. Assemble them into support, tapping outer race of bearing lightly with plastic hammer. Fit them fully, using steel bar or so on.
(5) Assemble seal cover(F, 261) to pump casing(271) and fix it with hexagon socket head bolts(406). Apply grease lightly to oil seal in seal cover(F). Assemble oil seal, taking full care not to damage it. For tandem type pump, fit rear cover(263) and seal cover(262) similarly. 36078MP13 (6) Assemble piston cylinder subassembly cylinder block(012), piston subassembly (151, 152), set plate(153), spherical bushing(156) and cylinder spring (157) . Fit spline phases of retainer and cylinder. Then, insert piston cylinder subassembly into pump casing(271). 8-17 36078MP12 36078MP14