3) DISASSEMBLY Since the regulator consists of small precision finished parts, disassembly and assembly are rather complicated. For this reason, replacement of a regulator assembly is recommended, unless there is a special reason, but in case disassembly is necessary for an unavoidable reason, read through this manual to the end before starting disassembly. (1) Choose a place for disassembly. Choose a clean place. Spread rubber sheet, cloth, or so on on top of work-bench to prevent parts from being damaged. (2) Remove dust, rust, etc. from surfaces of regulator with clean oil. (3) Remove hexagon socket head screw (412, 413) and remove regulator main body from pump main body.
Take care not to lose O-ring. REG01 (210-7) (4) Remove hexagon socket head screw (438) and remove cover(C,629) Cover(C) is fitted with adjusting screw (C,QI) (628, 925), adjusting ring(C, 627), lock nut(630), hexagon nut(801) and adjusting screw(924). Do not loosen these screws and nuts. If they are loosened, adjusted pressure- flow setting will vary. REG02 (210-7) 8-24