hyundai R510LC-7 — 3. PUMP DEVICE

4) ASSEMBLY (1) For assembly, reverse disassembly procedures, but pay attention to the following items. Always repair parts that were scored at disassembly. Get replacement parts ready before- hand. Mixing of foreign matter will cause malfunction. Therefore, wash parts well with cleaning oil, let them dry with jet air and handle them in clean place. Always tighten bolts, plugs, etc. to their specified torques. Do not fail to coat sliding surfaces with clean hydraulic oil before assembly. Replace seals such as O-ring with new ones as a rule. (2) Put compensating rod(623) into compen- sating hole of casing(601).

(3) Put pin force-fitted in lever(1, 612) into groove of compensating rod and fit lever (1) to pin force-fitted in casing. (4) Fit spool(652) and sleeve(651) into hole in spool of casing. Confirm that spool and sleeve slide smoothly in casing without binding. Pay attention to orientation of spool. Spool Feedback lever 8-27 (210-7) 8-28