hyundai R510LC-7 — 4. MAIN CONTROL VALVE

GROUP 4 MAIN CONTROL VALVE 1. REMOVAL AND INSTALL 1) REMOVAL (1) Lower the work equipment to the ground and stop the engine. (2) Operate the control levers and pedals several times to release the remaining pressure in the hydraulic piping. (3) Loosen the breather slowly to release the pressure inside the hydraulic tank. Escaping fluid under pressure can penetrate the skin causing serious injury. When pipes and hoses are disconnected, the oil inside the piping will flow out, so catch it in oil pan. 13031GE18 (4) Remove bolts and disconnect pipe. (5) Disconnect pilot line hoses. (6) Disconnect pilot piping.

45078MC01 (7) Sling the control valve assembly and remove the control valve mounting bolt. Weight : 420 kg (930 lb ) (8) Remove the control valve assembly. When removing the control valve assembly, check that all the piping have been disconnected. 2) INSTALL (1) Carry out installation in the reverse order to removal. 45078MC02 (2) Bleed the air from below items. Cylinder(Boom, arm, bucket) Swing motor Travel motor See each item removal and install. (3) Confirm the hydraulic oil level and recheck the hydraulic oil leak or not. 45078MC03 8-31