3) ASSEMBLY (1) General comments In this assembly section, explanation only is shown. For further understanding, please refer to the figures and photographs shown in the previous disassembly section. Figure in ( ) shown after the part name in the explanation refers to the reference identity number shown on the construction figure shown in the spares section. Cautions in assembling seal Pay close attention to keeping all seals free from handling damage and inspect carefully for damage before using them. Apply clean grease or hydraulic oil to the seal so as to ensure it is fully lubricated before assembly. Do not stretch seals so much as to deform them permanently.
In fitting O-rings, pay close attention not to roll them into their final position in addition, a twisted O-ring cannot easily untwist itself naturally and could thereby cause inadequate sealing and thereby both internal and external oil leakage. Tighten fitting bolts for all sections with a torque wrench adjusted to the respective tightening torque as shown on the corss section drawings of the spares section. a. b. c. d. e. (2) Main spool Apply loctite to thread of spools(3, 4, 6, 7, 9, 10, 11) and assemble spring seat, spring and spool end. Assemble spool end to spool after fixing spool with a vise attached wood. Be careful not to applying loctite too much.
ft ) Fit O-ring into housing and assemble spools(3, 4, 6, 7, 9, 10, 11) into housing. Assemble lock cap on housing and tighten hex socket bolt. Tightening torque : 2.4 ~ 2.6 kgf m (17.4 ~ 18.8 lbf ft ) Insert poppet, spring into spool(5) and then apply loctite to thread of spool. Fit O-ring and backup ring on the plug and then tighten plug. Assemble spring seat, spring, and spool end and then assemble spool end sub assy to spool after fixing spool with a vise attached wood. Tightening torque : 11 0.5 kgf m (79.7 3.7 lbf ft ) Fit O-ring into housing and assemble spool(5) into housing. Assemble lock cap on housing and tighten hex socket bolt. Tightening torque :
2.4 ~ 2.6 kgf m (17.4 ~ 18.8 lbf ft ) Insert poppet, spring into spool(8) and then apply loctite to thread for spool. Fit O-ring and backup ring on the plug and then tighten plug. Assemble spring seat, spring, and spool end and then assemble spool end sub assy to spool after fixing spool with a vise attached wood. Tightening torque : 11 0.5 kgf m (79.7 3.7 lbf ft ) Fit O-ring into housing and assemble spool(8) into housing. Assemble lock cap on housing and tighten hex socket bolt. Tightening torque : 2.4 ~ 2.6 kgf m (17.4 ~ 18.8 lbf ft ) Assemble short cap on housing and tighten hex socket bolt. Tightening torque : 11 0.5 kgf m (79.7 3.7 lbf Tightening torque :
11 0.5 kgf m (79.7 3.7 lbf ft ) 8-42