5. ASSEMBLING 5. ASSEMBLING 1) 1) GENERAL CAUTIONS GENERAL CAUTIONS (1) Clean each part fully with washing oil and dry it by blasting compressed air. It is better not to use waste cloths as much as possible. However, if they are to be used, use clean ones, and pay attention to not leaving lint and so on. Don't clean the friction plate with washing oil without fail. (2) Use the torque wrench in tightening fitting screws and plugs to their respective torque shown in page 8-72, 8-74. (3) When hammering is required, use the plastic hammer and try to hit parts lightly.
(4) Similarly to the disassembling procedures, the numeral in parentheses following each part name indicates its item number shown in the attached assembly drawings. 2) 2) ASSEMBLY OF REDUCTION GEAR ASSEMBLY OF REDUCTION GEAR (1) Assemble side plate E (144) and inner race (143) to carrier 1 (140). Assemble needle bearing (142). (2) Assemble sun gear 2 to carrier 1 and fit clip (162). (3) 8-110 480H8TM50 480H8TM51 480H8TM52