3) ASSEMBLY (1) Assemble cylinder head assembly Check for scratches or rough surfaces if found smooth with an oil stone. Coat the inner face of gland(3) with hydraulic oil. 21078DA37 Coat dust wiper(9) with grease and fit dust wiper(9) to the bottom of the hole of dust seal. At this time, press a pad metal to the metal ring of dust seal. Fit snap ring(10) to the stop face. Press here (Straight down) 9 Metal 36078CY24A Fit back up ring(7), rod seal(6) and buffer ring(8) to corresponding grooves, in that order. Coat each packing with hydraulic oil before fitting it. Insert the backup ring until one side of it is inserted into groove.
Right Wrong 8-157(3) 210-7 Rod seal(6) has its own fitting direction. Therefore, confirm it before fitting them. Fitting rod seal(6) upside down may damage its lip. Therefore check the correct direction that is shown in fig. 45078CY24 8-161