Adjustment: [1] SHIFT PIVOT [2] LOCK NUT 1) Move the remote control lever to the “N” (Neutral) position. 2) Loosen the shift pivot lock nut of the remote control cable (shift side) and detach the shift pivot from the shift link pin. 3) Check that the detent arm roller sets in the groove in the shift arm. 4) Turn the shift pivot right or left so that the shift pivot sets on the shift link pin smoothly. 5) Set the shift pivot on the shift link pin. Move the remote control lever back and forth several times to check that the detent arm roller is in the groove in the shift arm securely.
[4] SHIFT LINK PIN Check that the center of the neutral switch end aligns with the center of the flat part of the detent arm. Tighten the lock nut securely. If the detent arm roller is not in the groove in the shift arm, readjust. 6) After adjustment, install the front separate cover (P. 4-7). Install the engine cover (P. 4-2). [7] Align. [8] NEUTRAL SWITCH END [9] DETENT ARM ROLLER 3-25 [3] SHIFT A [1] SHIFT PIVOT [2] LOCK NUT [5] [6] FLAT PART OF [5] LAT PART OF GROOVE IN SHIFT ARM D ETENT ARM