11. SHIFT CONTROL CABLE [2] NEUTRAL SWITCH END [1] FLAT PART OF DETENT ARM Inspection: 1) Remove the engine cover (P. 4-2). Remove the front separate cover (P. 4-7). 2) Move the remote control lever to the “N” (Neutral) position. Check that the detent arm roller sets in the groove in the shift arm as shown. Check that the center of the neutral switch end aligns with the center of the flat part of the detent arm. 3) If the center of the neutral switch end does not align with the center of the flat part of the detent arm, check the detent arm for deformation and damage. [3] Align. Replace the detent arm with a new one if necessary (P. 17- 13).
If the detent arm roller is not in the groove in the shift arm, adjust (P. 3-25). [5] SHIFT ARM GROOVE [4] DETENT ARM ROLLER [4] DETENT ARM ROLLER [5] SHIFT ARM GROOVE [1] FLAT PART OF DETENT ARM [3] Align. [2] NEUTRAL SWITCH END [4] DETENT ARM ROLLER 3-24