3) Connect the pin jack, that is the opposite side from the cable 2P connector, to the digital tachometer. [1] PIN JACK [2] DIGITAL TACHOMETER (KOWA: KEK-8-MT600) How to connect the HDS (Honda Diagnostic System): 1) Disconnect the data link connectors (Red connector: 4P connector). [1] DATA LINK CONNECTORS (DLC) [RED: 4P CONNECTOR] 2) Connect the 4P connector that goes to the HDS to the engine side 4P connector. [2] HDS 4P CONNECTOR 5) Start the engine and let it warm up sufficiently. Run the engine under no load until the engine speed stabilizes, and check the idling speed. [1] HDS (Honda Diagnostic System) If the idle speed is out of the specification, adjust the idle (P. 5-94).
When the idle speed is outside the specification or when a problem symptom shown on the Idle Control System Troubleshooting Guide (P. 5-93) appears, perform the adjustment. 6) Install the engine cover (P. 4-2). 3-23 Specified idle speed (At neutral) 750 ± 50 min–1(rpm)