honda — Maintenance

7) Connect the water level sensor 2P connector and install the 2P connector on the connector bracket A. Route the water level sensor wire through the harness clip. Clamp at the taped part of the water level sensor wire and close the harness clip. [1] CONNECTOR BRACKET A [2] TAPED PART 8) Install the engine cover (P. 4-2). [3] HARNESS CLIP [4] WATER LEVEL SENSOR 2P CONNECTOR 10. IDLING [1] ELECTRIC PART COVER Inspection: Check the following before starting the idling inspection. – Spark plug gap (These models are equipped with the iridium spark plugs. If the spark plug gap is out of the specification, replace the spark plug with a new one.) (P. 3-8). – MIL must be OFF.

1) Place the outboard motor vertically (with the engine level to the ground), and set the remote control lever in the “N” (Neutral) position. 2) Remove the propeller. Set the outboard motor gear case in a test tank filled with water. Remove the engine cover (P. 4-2). 3) Remove the electric part cover. [1] ENGINE SPEED CHECK CONNECTOR [Blue 2P connector] 4) Install the commercially available digital tachometer (KOWA: KEK-8-MT600) or the HDS (Honda Diagnostic System). How to connect the digital tachometer (KOWA: KEK-8- MT600): 1) Disconnect the engine speed check connector (Blue connector: 2P connector).

2) Connect the 2P connector of the cable that is included in the digital tachometer kit (KOWA: KEK-8-MT600) to the engine side 2P connector. [2] CABLE included in digital tachometer kit. 3-22