Adjustment: [1] LINK PIN [2] THROTTLE ARM 1) Loosen the shift pivot lock nut of the remote control cable (throttle side), and remove the shift pivot from the throttle arm link pin. [4] SHIFT PIVOT [3] LOCK NUT 2) Screw in the shift pivot a little until the throttle arm contacts the full open stopper, and temporarily install the shift pivot on the throttle arm. 3) Move the remote control lever to the “F” (Forward) full open position (P. 3-26). 4) Check that step 3, 4 and 5 under the section of Inspection are satisfied (P. 3-26). If not, perform the adjustment procedure from step 1.
If the throttle arm is in contact with the full open side stopper but the step 4 or 5 is not satisfied, go to cam not in full open position>. [1] SHIFT PIVOT 5) Move the remote control lever to the “N” (Neutral) and tighten the shift pivot lock nut securely. Perform this adjustment with the remote control cable (throttle side) installed on the throttle arm. Be sure that the throttle arm is in contact with the full open side stopper. [3] THROTTLE ROD [2] LOCK NUT 1) Remove the throttle rod linkage pivot from the throttle plate and loosen the linkage pivot lock nut.
[1] LINKAGE PIVOT 2) With the throttle arm in contact with the full open side stopper, turn the throttle rod linkage pivot right or left to adjust the clearance between the throttle cam and the full open side stopper. It must be 1 mm (0.04 in) or below. 3) Temporarily install the linkage pivot on the throttle plate. 4) Check that step 3, 4 and 5 under the section of Inspection are satisfied (P. 3-26). If step 3 is not satisfied, readjust following the procedure of . If the throttle cam is in contact with the full open side stopper but the step 5 is not satisfied, go to not in full open position>. [4] THROTTLE PLATE 5) Tighten the linkage pivot lock nut securely. 3-27