3) Remove the alternator belt by removing it from the alternator pulley first, then from the crankshaft pulley. [1] ALTERNATOR BELT Do not contaminate the alternator belt with oil or grease. Do not bend the alternator belt. Store the belt by hanging it on the wall. Installation: 1) Install a new alternator belt on the crankshaft pulley first, then install the other end of the belt on the alternator pulley. NOTICE Do not turn the crankshaft pulley counterclockwise. [2] CRANKSHAFT PULLEY [3] ALTERNATOR PULLEY 2) Tighten the special adjusting bolt. Tighten the 8 mm flange nut and the 10 x 80 mm flange bolt in this order to the specified torque. TORQUE: 8 mm flange nut: 26 N . m (2.7 kgf .
m, 20 lbf . ft) 10 x 80 mm flange bolt: 44 N . m (4.5 kgf . m, 33 lbf . ft) [1] 8 mm FLANGE NUT 10 x 80 3) After tightening the nut and bolt to the specified torque, check the belt tension and deflection (P. 3-29). 4) Install the silencer duct assembly (P. 3-11 and 12). Install the engine cover (P. 4-2). [2] SPECIAL ADJUSTING BOLT [3] ALTERNATOR ASSEMBLY 3-30