[1] BELT TENSION GAUGE 07JGG-0010101 2) If the belt tension is out of the specification, adjust the belt tension. [1] BELT DEFLECTION b. Belt deflection inspection 1) Measure the belt deflection by pushing the alternator belt at the center between the pulleys with 98 N (10 kgf, 22 lbf) of force. [2] When pushed with 98 N (10 kgf, 22 lbf) of force. 2) If the belt deflection is out of the specification, adjust the belt tension. [1] 8 mm FLANGE NUT Belt Tension Adjustment:
10 x 80 1) If the belt tension or belt deflection is out of the specification, loosen the 10 x 80 mm flange bolt and the 8 mm flange nut, and adjust the belt tension or deflection by turning the special adjusting bolt right or left. 2) After adjustment, tighten the 8 mm flange nut and the 10 x 80 mm flange bolt in this order to the specified torque. TORQUE: 8 mm flange nut: 26 N . m (2.7 kgf . m, 20 lbf . ft) 10 x 80 mm flange bolt: 44 N . m (4.5 kgf . m, 33 lbf . ft) [2] SPECIAL ADJUSTING BOLT [3] ALTERNATOR BELT 3) After tightening the bolt and nut to the specified torque, check the alternator belt tension and deflection again.
If the measurement is still out of the specification, repeat the step 1 and 2. 10 x 80 [1] 8 mm FLANGE NUT Replacement: 1) Loosen the 10 x 80 mm flange bolt and the 8 mm flange nut. 2) Loosen the special adjusting bolt and move the alternator assembly fully to the engine side. [2] SPECIAL ADJUSTING BOLT [3] ALTERNATOR ASSEMBLY 3-29 a. Best tension check using belt tension gauge: 1) Set the special tool at the center between the alternator belt pulleys, and measure the belt tension. TOOL:
Belt tension gauge 07JGG-0010101 Belt tension Used belt 329 – 490 N (40 – 50 kgf, 88 – 110 lbf) New belt 490 – 588 N (50 – 60 kgf, 110 – 132 lbf) Belt deflection Used belt 10.6 – 11.1 mm (0.42 – 0.44 in) New belt 10.1 – 10.6 mm (0.40 – 0.42 in)