honda — Engine Cover/Cover Lock

e. R. ENGINE UNDER COVER ASSEMBLY 1) Position the water joint cap on the R. engine under cover and tighten the 16 mm hex. nut securely. Note the installation direction of the water joint cap. 2) Position the power tilt switch on the power tilt switch grommet with the “UP” mark on the power tilt switch facing up. 3) Install the power tilt switch on the R. engine under cover and install the power tilt switch stay as shown. Secure the power tilt switch stay with the locking lugs of the power tilt switch. [1] 16 mm HEX. NUT [7] POWER TILT SWITCH STAY [6] POWER TILT SWITCH STAY GROMMET [2] WATER JOINT CAP [5] POWER TILT SWITCH [4] LOCKING LUGS [3] R. ENGINE UNDER COVER f.

INSTALLATION 1) If the water check grommet is not mounted on the L. engine under cover, install it from the outside of the L. engine under cover. [1] 7 x 400 mm TUBE 2) Connect the 7 x 400 mm tube to the water check grommet. [2] WATER CHECK GROMMET 3) Install the L. engine under cover aligning the bottom edge of the L. engine under cover with the extension case as shown. [1] L. ENGINE UNDER COVER [2] Align. [3] EXTENSION CASE 4-14