honda — Engine Cover/Cover Lock

4) Install the L. engine under cover aligning the hole in the L. engine under cover with the projection on the L. side cover bracket. [1] L. ENGINE UNDER COVER [2] PROJECTION [4] HOLE [3] L. SIDE COVER BRACKET 5) Check that the cover lock cable A is set on the L. engine under cover as shown. [1] L. SIDE COVER BRACKET [4] COVER LOCK CABLE A [2] L. ENGINE UNDER COVER [3] Cross section viewed from A-A side. A A [2] L. ENGINE UNDER COVER 6) Hold the power tilt switch wire above the R. engine under cover. 7) Install the R. engine under cover aligning the bottom of the R. engine under cover with the extension case as shown. Note that the 8 x 300 mm tube with the flush plug cap is outside the R.

engine under cover this time. [1] R. ENGINE UNDER COVER [2] Align. [3] EXTENSION CASE 4-15