8) Align the projections at the front side (i.e. swivel case side) of the L. engine under cover with the recess in the R. engine under cover as shown. [1] RECESS [2] R. ENGINE UNDER COVER [4] PROJECTIONS [3] L. ENGINE UNDER COVER 9) With the R. engine under cover held in alignment with the L. engine under cover described in step 7, install the R. engine under cover by aligning the hole in the R. engine under cover with the projection on the R. side cover bracket. [1] PROJECTION [2] R. ENGINE UNDER COVER [3] HOLE [4] R. SIDE COVER BRACKET 10) Check that the cover lock cable B sets underside the R. engine under cover as shown. [1] Cross-section viewed from A-A side. [2] R.
ENGINE UNDER COVER A [3] COVER LOCK CABLE B A [3] COVER LOCK CABLE B [2] R. ENGINE UNDER COVER 4-16