honda — Engine Cover/Cover Lock

11) Install the L./R. engine under covers aligning the projection on the rear (i.e. cylinder head cover side) of the L. engine under cover with the recess in the R. engine under cover. Install the L./R. engine under covers, too, aligning the projections at the upper part of the L. engine under cover with the recess at the upper part of the R. engine under cover. Check that each alignment performed in step 4 through step 11 is not out of alignment. 12) Loosely tighten the three 6 x 25 mm screws and the eleven 6 x 17 mm special bolts on the L./R. engine under covers. Check that the special bolts are not on the case but they are tightened properly.

13) Tighten the three 6 x 25 mm screws to the specified torque and the eleven 6 x 17 mm special bolts to the standard torque in the numbered sequence and in two or three steps securely. TORQUE: 6 x 25 mm screws: 4.5 N . m (0.45 kgf . m, 3.3 lbf . ft) STANDARD TORQUE: 6 x 17 mm special bolts: 4.2 N . m (0.42 kgf . m, 3.0 lbf . ft) Check that each alignment performed in step 4 through step 11 is not out of alignment. [2] R. ENGINE UNDER COVER [1] L. ENGINE UNDER COVER ⑥ ⑪ ⑫ ① ⑬ ⑦ ② ⑭ ④ ⑨ ③ ⑤ ⑩ ⑧ [4] 6 x 17 mm SPECIAL BOLT (11) [3] 6 x 25 mm SCREWS 4-17 [1] L. ENGINE UNDER COVER [2] PROJECTION [3] RECESS [4] R. ENGINE UNDER COVER [1] [2] [4] L. ENGINE PROJECTIONS R.

ENGINE UNDER UNDER COVER COVER [3] RECESS 4] R. ENGINE UNDER COVER [3] RE CESS [1] L. ENGINE UNDER COVER 2] PROJECTION