UNDER COVER FRONT BRACKET: [2] 6 mm E-RING [3] 8 mm WASHER 1) Install the bracket cap. [1] COVER LOCK BUSHING A 2) Apply marine grease to the front lock shaft and the outer surface of the cover lock bushing. [4] (MARINE GREASE) 3) Apply marine grease to the outer surface of the cover lock hook spring. Install the cover lock hook spring aligning its hook with the hole in the front lock. [9] BRACKET CAP 4) Set the front lock in the position shown. Install the front lock on the under cover front bracket at an inclined angle. [7] HOLE 5) Install the cover lock hook spring on the under cover front bracket aligning its hook with the hole in the under cover front bracket.
[8] COVER LOCK BUSHING [5] COVER LOCK HOOK SPRING 6) Apply marine grease to the outer surface of a cover lock bushing A and install it on the under cover front bracket. 7) Install the 8 mm washer and the 6 mm E-ring on the front lock. [6] FRONT LOCK [4] (MARINE GREASE) [7] HOLE [6] FRONT LOCK [10] UNDER COVER FRONT BRACKET [6] FRONT LOCK 8) Apply marine grease to the outer surface of the cover open shaft, lock lever return spring, 8 mm washer and the cover lock bushing B. Install the lock lever return spring, 8 mm washer, and the cover lock bushing B on the cover open shaft. Hold the lock lever return spring compressed with the cover lock bushing B.
9) Install the cover open shaft at an inclined angle in the under cover front bracket. 10) Install the cover lock bushing B in the under cover front bracket. 11) Install the 6 mm E-ring on the cover open shaft. 4-29 [1] UNDER COVER [2] (MARINE FRONT GREASE) BRACKET [6] COVER OPEN SHAFT [3] [5] COVER LOCK LOCK BUSHING B LEVER RETURN SPRING [4] [2] (MARINE GREASE) 8 mm WASHER [4] 8 mm WASHER