16) Adjust the length between the other end of the cable outer and the end of the nut of the cover lock cable B so that it is 13 mm (0.5 in) as shown. 17) Holding the nut in the position described in step 16, position the inner cable end of the cover lock cable B on the side lock and position the cable B nut on the R. side cover bracket. 13 mm (0.5 in) [2] R. SIDE COVER BRACKET SIDE Tighten the washer side lock nut securely. [1] COVER LOCK CABLE B [4] STOPPER Check that the nut set in step 16 is not out of the position. If it is, repeat the procedure from step 16. [3] Contact. 18) Check for clearance between the end of the long hole in the side lock and the inner cable end as shown.
There must be no clearance. If there is clearance, repeat the procedure from step 7. Check that the side lock is in contact with the stopper of the R. side cover bracket. [7] LOCK NUT [6] SIDE LOCK 19) After installing the cover lock cable A and B, operate the cover lock lever and check the front lock and the L./R. side locks for smooth operation. [1] View of each bracket from the top: 20) Pull up the cover lock lever (i.e. release the cover lock). Look down the cover lock bolt hole of each of the under cover front bracket and the L./R. side cover brackets and check that the front lock and the side lock do not appear.
[2] FRONT LOCK or SIDE LOCK [3] COVER LOCK BOLT HOLE (The front lock and side lock must not appear when viewing the cover lock bolt hole from the top with the lever pulled up.) 21) If the front lock or side lock appears when looking down the cover lock bolt hole, perform the following check. Loosen the lock nut at the cover lock cable A of the L. side bracket, and adjust by turning the adjusting nut right or left. [4] L. SIDE COVER BRACKET SIDE: Loosen the lock nut at the cover lock cable B of the R. side bracket, and adjust by turning the adjusting nut right or left. [5] COVER LOCK CABLE A [6] LOCK NUT 22) Install the following parts. – Remote control cable/grommet (P. 17-5) – L./R.
engine under cover (P. 4-14) – Front separate cover (P. 4-7) – Engine cover (P. 4-2) [7] ADJUSTING NUT 4-34 [5] No clearance.