10) Adjust the length between the other end of the cable outer and the end of the nut of the cover lock cable A so that it is 13 mm (0.5 in) as shown. 11) Holding the nut in the position described in step 10, position the inner cable end of the cover lock cable A on the side lock and position the cable A nut on the L. side cover bracket. Tighten the washer side lock nut securely. Check that the nut set in step 10 is not out of the position. If it is, repeat the procedure from step 10. 12) Check for clearance between the end of the long hole in the side lock and the inner cable end as shown. There must be no clearance. If there is clearance, repeat the procedure from step 7.
Check that the side lock is in contact with the stopper of the L. side cover bracket. 13) Adjust the length between the end of the cable outer and the end of the nut of the cover lock cable B (shorter one) so that it is 13 mm (0.5 in) as shown. 13 mm (0.5 in) [1] L. SIDE COVER BRACKET SIDE 14) Holding the nut in the position described in step 13, position the inner cable end of the cover lock cable B on the side lock and position the cable B nut on the L. side cover bracket. [2] COVER LOCK CABLE B Tighten the washer side lock nut securely. Check that the nut set in step 13 is not out of the position. If it is, repeat the procedure from step 13.
[3] SIDE LOCK [4] STOPPER 15) Check for clearance between the end of the long hole in the side lock and the inner cable end as shown. There must be no clearance. [5] Contact. If there is clearance, repeat the procedure from step 7. [6] LOCK NUT Check that the side lock is in contact with the stopper of the L. side cover bracket. [7] No clearance. [2] COVER LOCK CABLE B 4-33 13 mm (0.5 in) [2] [1] L. SIDE COVER COVER LOCK BRACKET SIDE CABLE A [4] [3] LOCK STOPPER [5] NUT Contact. [7] No clearance. [6] SIDE LOCK [1] COVER LOCK 13 mm (0.5 in)