honda — Engine Cover/Cover Lock

6) Check that the taped ends of the power tilt motor wire and trim angle sensor wire are in alignment with the end of the undercase grommet C. Install the undercase grommet C on the under cover front bracket so they engage securely in the groove of the undercase grommet C. [2] Wires and tube must not interfere with the lock lever. [1] FRONT LOCK Move the front lock with a hand and check that the wires and tube do not interfere with the front lock.

[3] TAPED PART [7] UNDERCASE GROMMET C [6] SPEED SENSOR TUBE A [4] POWER TILT MOTOR WIRE [5] TRIM ANGLE SENSOR WIRE 7) Adjust the length between the end of the cable outer and the end of the nut of the cover lock cable A (longer one) so that it is 20 mm (0.8 in) as shown. 20 mm (0.8 in) 8) Holding the nut in the position described in step 7, position the inner cable end of the cover lock cable A on the front lock and position the cable A nut on the under cover front bracket. Tighten the washer side lock nut securely. [1] UNDER COVER FRONT BRACKET SIDE Check that the nut set in step 7 is not out of the position. If it is, repeat the procedure from step 7.

[2] 4 x 7 x 160 mm VINYL TUBE 9) Position the 4 x 7 x 160 mm vinyl tube and the 3.5 x 430 mm fuel tube on the under cover front bracket. [3] COVER LOCK CABLE A [4] LOCK NUT [5] 3.5 x 430 mm FUEL TUBE [6] FRONT LOCK 4-32