3) Install the under cover front bracket securely with the two 8 x 30 mm hex. bolts and the two 8 mm washers. [1] UNDER COVER FRONT BRACKET [2] 8 mm WASHER (2) [3] 8 x 30 mm HEX. BOLT (2) 4) Pass the tube and the wires through the hole in the under cover front bracket. [1] UNDER COVER FRONT BRACKET [2] WIRES [3] TUBE [5] UNDERCASE GROMMET C [4] HOLE 5) Connect the trim angle sensor 3P connector and the power tilt motor 2P connector. Install the power tilt motor 2P connector on the lower side of the connector bracket A and the trim angle sensor 3P connector on the upper side of the connector bracket A.
[1] TRIM ANGLE SENSOR 3P CONNECTOR [2] POWER TILT MOTOR 2P CONNECTOR [3] CONNECTOR BRACKET A 4-31